Industrial Duty - Totally Enclosed Fan Cooled - Phase Converter Built in Phoenix Arizona, Phoenix Rotary Phase Converter Delivery Precision Balanced 3-phase Voltage from a Single Phase Power Supply.
Cast Iron Frame, Corrosion Resistant Hardware, Stainless Steel Connection Plate, Cast Iron Conduit Box, Over Sized Bearings, Cast Iron Inner & Outer Bearing Retainers, Vacuum Impregnated Windings, 4140 Steel Shaft Rotor
Generator is made to preform in a wide range of environments and we prepare them for the task.
From the cast iron frame and dual oversized bearings and seals.
This generator is ready for the toughest environments.
We use a terminal block that is a convenient way to manage your power distribution needs. UL Listed, rated for copper or aluminum conductors, Tin-plated, with safety covers on larger converters, Easy Connection, non-corrosive and oversized. We use this block with the consumer in mind, makes your installation easy, fast, and secure.
Totally Enclosed, Fan Cooled
This motor is probably the most commonly used motor in ordinary industrial environments. It costs a bit dollars more than the open motor, yet offers good protection against common hazards.
The motor is constructed with a small fan on the rear shaft of the motor, usually covered by a housing. This fan draws air over the motor fins, removing excess heat and cooling the motor.
The enclosure is "Totally Enclosed". This ordinarily means that the motor is dust tight, and has a moderate water seal as well. Designed to withstand regular washing, such
Voltage Panel Display
Either monitor your single phase voltage or your generated phase for consistency, 3 1/2 inch, blue backlight, make it easy to see. Without opening up any covers and using a voltmeter you can always see that the phase converter is working properly for your equipment. It will shut on and off with your phase converter.
Digital Protection & Push Button Control
Whether you are in a rural area or not, voltage drops or dips can occur, this will protect the component inside the phase converter, it will also protect against overloading the phase converter. This will help eliminate costly labor, material, and down time.
Easy way to turn on the phase converter with out using a disconnect or breaker to power the phase converter, it also provides a level of safety, if the event you ever lose power, the phase converter will stay off when the power is restored.
Push Button Indicating Light
The indicating light is actually LED, consumes less power, much brighter, and last 1000 times longer then a traditional bulb.
We are neat freaks
Not a single phase converter leaves our facility, unless it is absolutely perfect, no crossed wires, secure tied downs, all hand built and goes through a four level inspection process right before it is packaged and shipped. Heavy gauge wire and thick insulation, resistant to heat and moisture.