Call Us toll Free 1-800-417-6568
Flat Rate Shipping On Phase Converters
Total Weight: 204.0000 lbs.
Idler Enclosure: Totally Enclosed Fan Cooled
If Ordered by 2PM
Operations Manual
The 10 HP Rotary 3 Phase Converter - GP10PL is equipped with a 4140 steel shaft rotor generator that features a cast iron frame, corrosion resistant hardware, stainless steel connection plate, cast iron conduit box, over sized bearings, cast iron inner & outer bearing retainers, and vacuum impregnated windings. From the cast iron frame and dual oversized bearings and seals. This generator is ready for the toughest environments.
We use a terminal block that is a convenient way to manage your power distribution needs. UL Listed, rated for copper or aluminum conductors, Tin-plated, with safety covers on larger converters, Easy Connection, non-corrosive and oversized. We use this block with the consumer in mind, makes your installation easy, fast, and secure.
Cast Iron Frame, Corrosion Resistant Hardware, Stainless Steel Connection Plate, Cast Iron Conduit Box, Over Sized Bearings, Cast Iron Inner & Outer Bearing Retainers, Vacuum Impregnated Windings, 4140 Steel Shaft Rotor Generator is made to preform in a wide range of environments and we prepare them for the task. From the cast iron frame and dual oversized bearings and seals. This generator is ready for the toughest environments.
The 10 HP Rotary 3 Phase Converter - GP10PL includes a 3 1/2 inch display that makes it easy to either monitor your single phase voltage or your generated phase for consistency. Without opening up any covers and using a voltmeter you can always see that the phase converter is working properly for your equipment. It will shut on and off with your phase converter.
Whether you are in a rural area or not, voltage drops or dips can occur, this will protect the component inside the phase converter, it will also protect against overloading the phase converter. This will help eliminate costly labor, material, and down time. Easy way to turn on the phase converter with out using a disconnect or breaker to power the phase converter, it also provides a level of safety, if the event you ever lose power, the phase converter will stay off when the power is restored.
We are neat freaks
Not a single phase converter leaves our facility, unless it is absolutely perfect, no crossed wires, secure tied downs, all hand built and goes through a four level inspection process right before it is packaged and shipped. Heavy gauge wire and thick insulation, resistant to heat and moisture.
The indicating light is actually LED, consumes less power, much brighter, and last 1000 times longer then a traditional bulb.
| Add Push Button, Mag Starter & Voltmeter | Yes |
|---|---|
| Generator Enclosure | TEFC |
| Kilo-watt | 7.5 |
| KVA | 3 |
| Max Circuit Breaker | 50 |
| Minimum Wire Size | 6 AWG |
| Max, Fuse Size | 50 |
| Min. Fuse Size | 20 |
| Minimum Wire to Generator | 8 AWG |
| Output Amperage | 28 |
| Minimum Service Required | 15 KVA |
| Voltage Output | 230 |
| Voltage Balance | +/- 2% |
| Minimum Wire to Load | based on load |
| Max Resistive Amps | 14 |
| Generator Frame | 215T |
| Frequency (Hz) | 50/60 |
| Product Quote | No |
| SEO Name | 10 HP Rotary Phase Converter - 1 to 3 Phase Converter |
